Before installing a double -leaf door in the opening, you need to convince that you have 125 cm of the free space of the doorway. If you bought standard doors, then it is enough to have 60 cm of space. Since you will work on the floor, all possible irregularities must be excluded, because they can affect the appearance of the door details and assembly accuracy. If you buy beautiful and high -quality double doors, you hardly want to ruin them with poor -quality installation. The presence of a pile will significantly speed up the process of installing doors, since for this you will have to assemble a box, and also fasten the loops.
Previously, the doorbroof bars need to be drilled under the screws. After that, they are screwed to short, and the door leafs are laid out in the frame. Between the elements of the box and the door leaf, gaps form, which are exhibited three millimeters.
Retreat 30 mm from each door of the lower edge and make a mark with a pencil on the side bars of the box. After that, carefully cut all the excess of the beam. If the door is installed in the room with a large slope of the floor, then the gap must be calculated separately using the level and roulette.
After that, you can mark the places under the loops. 12 cm loops will be enough for installing 60 cm of paintings, at the same distance from the bottom and the top of the double door. Circle the loop with a pencil by laying the door to the rib. After that, select a landing depression with chisels. The installation of double -leaf doors often provides for the installation of accessories on a flush with the surface of the door material.
Again lay on a box of doors with screwed loops. In order to mark opposite recesses after the sample, the loops must be screwed to the box. After that they are removed from the loops, and the door box is installed in the level in the interior opening. The top of the canvas is blocked by wedges, and a crossbar is laid below to avoid a skew. If there is no lower crossbar, then the boxes are attached to the ceiling and walls using anchor bolts. Their hats can be scored into wood by 1 mm, and then putting.
Now in the doorway you can drill technological holes for the valves and pens. Everything, the door can be hung in place, and the gap between the box and the wall should be closed with the platband.
