Plastic panels are widely used where walls and ceilings are finished. In apartments, plastic panels are performed by lining of the kitchen, bathroom, hallway, corridors and so on. In suburban houses, the panels are installed for a while, until a complete shrinkage of the house. They have elasticity and are very resistant to wall deformations, which allows you to maintain the finish in perfect condition.
They are produced using extrusion made of polyvinyl chloride. To increase elasticity and durability, impact resistance, special additives are used.
Due to the fact that the panel consists of numerous isolated cells, this material has high thermal insulating properties. Applying a special printing, a decorative pattern is applied to the panel, covered with a layer of varnish, which provides antistatic and wear resistance, as well as counteracting sunlight. The coating can have a glossy or matte-sloping surface. With the help of a wave -like surface, original light effects are achieved. High hygienic requirements are fully satisfied with the non -cilular surface structure and the absence of pores.
PVC panels are not terrible high humidity. They can be used even where increased humidity is observed. Dust never accumulates on such panels. It is easy to remove dirt from them with a damp cloth moistened in a washing agent that does not contain chlorine and abrasive. This material tolerates any temperature changes perfectly, it is fireproof.
The panels are produced in standard sizes, but the length can be any and made to order. To calculate the consumption of the material, if the height of the room is less than the length of the panels, it is necessary to divide the perimeter into the width of the panel, while you do not need to take into account the dimensions of the doors and windows.
Plastic panels help to hide various engineering communications and thermal insulation. They are attached in such a way that not a single seam is noticeable. The wall in this case looks like one whole. The low cost of panels compared to similar finishing materials, the possibility of their independent installation turns them into the most affordable option with a lack of means.
Installation is always carried out on the surface or to the existing supporting structure. The installation of the crate is preliminarily performed. In rooms with high humidity, wood or fasteners made of stainless metal are used after preliminary processing. Reiki must be installed at a distance from each other about 60 cm. The main rails are set at an angle of 90 degrees to the facing profile.
