In this article, we will consider how to connect (additives) beams on rafters. After all, the lengths of the beams are different, in the forest science there are 4m, 4.5m and 6m how right such standards. Read also the mount and installation of beams, the bastard on the walls.
For example, we have such a roof that the length of the rafter 6.8 meters, and we have 6m beams, it turns out that we need to add 80cm to each rafter beam. In such cases, we make the following mount as shown in the photo and consider how it is done.
On a visual example, beams of 100×50 beams are uniform, beams are connected using studs with a diameter of 1cm, nuts, washers and nails using linings from the same beam. Initially, the beam and additive are prepared to the beam, then from the top and from the bottom we lay a lining about 1 meter long and clogs 2 nails on each side of the beam, nails in size of 200 mm, then the nails are bent with ticks (paskets) and clogged into an pull. Then 2 holes are drilled on each side of the beams through the drill along the diameter of the hairpin. Prepared pieces of studs are inserted into the holes and tighten up by inserting the washers and nuts.
Everything on this connection ends. As a result, a rather strong connection will eliminate how it is and gnaws in the photo. Such compounds are reliable, since the rafters are a rather important element in the roof. You can thus connect the beams of the ceiling (bastard) and other options.
Want to buy a cottage? Cottage villages in the Vyborg district excellent solution.
