Any large -scale repair work should begin with the most dirty and laborious work. If you are going to carry out a redevelopment in the apartment, then start with the dismantling of the ceilings and the construction of new. Suppose a high -quality parquet has been preserved in your apartment, which does not require replacement as a wardrobe for a coupe in the bedroom, and you are very afraid that construction work can destroy it. Then you should cover it with plastic film, but after the end of the main repair work, you still have to re -cover the parquet with varnish.
After replacing the floors, you need to proceed to the removal of the old coating from the ceiling and walls of the apartment. In the houses that were built decades ago, a well -known whitewash was used as a wall covering and ceiling, such a coating is easiest to remove. It is enough to blur with lime a little and you can apply new materials to cover. It is advisable to wash off the known whitewashing to the last layer of putty, if you want new coating materials to last long. The procedure is extremely simple, but quite time -consuming, how well you removed the well -known whitewashing will depend on the clutch of a new coating with the walls of the house or apartment.
The well -known whitewash should be removed by blurring with a painted roller soaked in water. Sometimes, in order to completely remove the whitewashing from the walls, you need to repeat the procedures repeatedly, it will remove its residues from the surfaces with a simple wet sponge.
The dismantling of wallpaper is not very different from the process of dismantling the known whitewash. First you need to remove those sections of the wallpaper that can be removed “in dry”, then remove the areas firmly glued to the walls, blurring them with water. Some modern wallpapers are very easily removed from the walls, while leaving only a small layer of wrong paper, which is far from always necessary to remove from the walls.
