After the old box is dismantled, the doorway is measured, it should be around the perimeter more than ten millimeters more than the box, this gap will be filled in the future at the time of installation of the door. Next is the door box assembled. The upper bar and the racks of the box are cut “in the mustache” at an angle of 45 degrees, and attached by self -tapping screws. The door is hung on the loop, the stand is placed strictly vertically using a level or plumb line, and the lock stand should be adjustable along the door of the door with a gap of 0.3 mm, the gaps are fixed using cardboard gaskets. In the opening, the box is fixed for a while with wooden wedges, the gap between the opening and the door frame is filled with foam, after wetting the walls of the opening with water for a better coupling.
It also happens when the width of the box and the opening is different, and in order to compensate for this difference, the premature bar is used, it is made in the tone of the doors, mounted in the groove of the box and fixed with the help of self -tapping screws. If necessary, in rooms with large cross -country ability, the box is additionally fixed to the walls of the opening with screws whose hats are closed with decorative plugs. Then the perimeter of the mounted box after the foam hardens, cash out. The upper and two rack strips are also washed down at an angle of 45 degrees, and fixed on the box using decorative finished nails or simply glued. After that, the lock is installed using feather or milling. The installation of the door came to an end, it remains only to check the correct installation. If there is no friction of the door about the box and spontaneous opening, then the installation passed correctly. Subject to proper care of the product, the door will serve you for a long time.
