A board is folded over the foundation, before it is impregnated with bitumen. These boards should have a width of at least one hundred and fifty millimeters and a thickness of fifty millimeters, then they put a bone of salary on top of it, which is protered from below, and then, still adjusted, all the remaining ones. In adjacent crowns, the logs are laid down in the antagonistic sides. Do not forget to check and, if necessary, correct the verticality of all angles, as well as the horizontalness of all the stacked crowns.
The crowns are attached to each other with rods made of wood (they have a diameter of twenty millimeters) in a chess sequence with a step of one and a half to two meters. In the walls, the mount goes at a distance of fifteen to twenty centimeters from the edge of the pie, but not less than two pieces.
When folding the crowns, in correspondence with the drawing, the openings are left for doors and windows. To place a blocking crown, you need to cut the opening along the plumb line, finish the ends so that they end with the rowing of the vertical direction. The upper and lower part of the opening must be without a crest. When installing boxes in the openings and jambs, you need to leave four or five centimeters for a shrinkage in height.
Upon completion of the construction of the walls, they need to be picked up with flax, bag, hemp, moss or felt, any of these materials is cut into stripes, and the dad or moss is still pre -dried (but at the same time, not allowing their brittleness). Put the material of the hemp so that its edges hang by thirty to forty millimeters, then make sure that there are no cracks, they compact these excesses into the grooves. If necessary, the material is added. Hemp is necessary from all crowns located below, but not a separate wall, because because of this it can simply sneak the entire structure. The first to take a log house at the first of all, and then from the inside.
